Read the room.
Three mmWave inputs and two PIR activity channels capture raw signals. They don’t make the decision.
RAW INPUT → VALIDATIONEcoSwitch detects occupancy, interprets inactivity, and intelligently manages classroom energy zone by zone.
Presence keeps it on.
Emptiness starts the clock.
At 1×, one real second is one simulated minute. Warning at 10 minutes. Shutdown at 15. Timers are independent.
24 GHz FMCW radar detects human presence and micro-motion within the configured sensing region.
Radar reflections from static objects and environmental geometry require appropriate placement and calibration.
Motion ≠ continuous presence. PIR detects movement/activity rather than continuously proving that a person remains present.
Three mmWave inputs and two PIR activity channels capture raw signals. They don’t make the decision.
RAW INPUT → VALIDATIONThe ESP32-S3 validates a stable input before the occupancy engine changes a zone’s state.
ESP32-S3 → OCCUPANCY ENGINEEach zone keeps its own inactivity timer. Confirmed presence resets it; PIR activity restarts its grace period.
ZONE STATE → IDLE TIMERAt 10 simulated minutes, the zone turns amber. The OLED shows a countdown and the buzzer signals a warning.
10 MINUTES → BUZZER + OLEDAt 15 minutes, lights and fans shut down in that zone only. Returning presence automatically restores power.
POWER CONTROL → LIGHT / FANEvery part has a purpose.
Select one to get closer.
Illustrative prototype hardware, not a verified fabrication drawing. GPIO assignments below are a proposed demonstration map. Verify your exact board, sensor interfaces, driver ratings, and power supply before building.
From a quiet sensor signal to a decisive power switch. One occupancy engine keeps the classroom, controls, and displays in agreement.
Raw inputs aren’t decisions.Stable presence is validated before it changes a zone.
Independent by design.One empty zone never interrupts an occupied one.
Visible at every step.State, timing, and power are reflected on the OLED and in the event log.
Explore the connections.
Click a wire. Select a pin.
3.3 V logic · Regulated 5 V motor rail · Common ground
Power supplies shown are planning representations. Always regulate before the motors or controller.
Classroom luminaires are represented by low-current LEDs. The 40 W / 50 W energy model does not describe GPIO loads. Real lighting needs appropriately rated, isolated switching hardware.
Change an input. Watch the response.
This isn’t a video. It’s the system.
Simulated device health. No hardware connected.
Browser audio is off until you enable it.
Assumptions, not measured real-world values. Estimated energy avoided: 0.00000 kWh. Shutdown time is cumulative across zones.
Explore the complete architecture, sensing strategy, control logic, hardware design, and prototype implementation.
Open technical PDF ECOSWITCH / TECHNICAL DOCUMENTATIONCurious about the prototype, the hardware, or bringing EcoSwitch to your classroom? Send a message and we will get back to you.